Giantec tracer2000 User Manual download pdf (Page 26)

tracer2000 Network DVR Hardware User’s Manual

Version 3.1 Page 18 of 31

3.2 P/T/Z Setting

The P/T/Z Setting complies with LILIN or PELCO. Protocol has been previously

attached to the COM ports. You may control the camera via arrow buttons.

In this case, you don’t need to buy dedicated P/T/Z controller.

3.3 Pin Assignment of COM2

Connect 9 PIN Female D_SUB to COM2 (Pin defines as below).

RS232 / RS422 / RS485 Connector (COM2)

Pin No. RS232 RS422 RS485

1 DCD TX- DATA-

2 RX TX+ DATA+

3 TX RX+

4 DTR RX-

5 GND GND GND

6 DSR RTS-

7 RTS RTS+

8 CTS CTS+

9 RI CTS-

Note: Please setup mode type by JP3.

3.4 Cable Connection

Camera input jack to COM2 for PIH-7000/7600. For example:

3.5 Jumper 3 Setting of COM2

The system default of COM2 is RS485. Adjust jumper JP3 in system for RS422,

RS232 signals as show below.

JP3

RS485

JP3

RS422

JP3

RS232

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 38 39

No comments

Giantec tracer2000 User Manual Page 26